Addressable Devices Addressable Devices & Detectors
The Addressable Multiplexed Loop (AML) provides the ultimate in simple, flexible and affordable zone expansion. Save time and money by connecting any addressable detector anywhere on the 2-wire AML loop. DSC has everything you need, including isolators and repeaters, so there is no limit to what you can do.

AMB-300

Addressable Passive Infrared Detector

• Based on the Bravo 3 hardwire motion detector
• Patented MLSP (Multi-Level Signal Processing)
• Interchangeable lens:
  Wall-to-wall lens (standard), curtain lens, pet-immune lens and corridor lens
• Built-in tamper switch

AMB-600

Addressable Pet-Immune Passive Infrared Detector

• Based on the Bravo 6 hardwire motion detector
• Patented MLSP (Multi-Level Signal Processing)
• Provides pet immunity up to 85 lbs (38 kg)
• Built-in tamper switch

AMB-500

Addressable Ceiling-Mount Passive Infrared Detector

• Based on the Bravo 5 hardwire motion detector
• Patented MLSP (Multi-Level Signal Processing)
• Coverage diameter based on mounting height
• Built-in tamper switch

AMA-100

Addressable Glassbreak Detector

• Based on the Acuity hardwire glassbreak detector
• Detects all types of breaking glass
  Plate, laminated, safety and tempered
• Can be tested using the AFT-100 Glassbreak Tester
• Built-in tamper switch

 AMS-220/ AMS-220T

Addressable Photoelectric Smoke Detector

• Based on the Meridian hardwire smoke detector
• ‘T’ model has built-in heat detector:
  135° F (57° C) fixed-temperature heat sensor
• Manual and programmable test for communication
• Automatic low sensitivity test
• Built-in tamper switch

AMP-700/AMP-701/ AMP-702/AMP-704/AMP-704F

Addressable Contact Modules

• AMP-700 door/window contact with built-in reed switch
• AMP-701 door/window contact with normally closed input
• AMP-702 fire point module with normally open, EOL resistor supervised input
• AMP-704 four door/window contacts with normally closed, single or double EOL inputs
• AMP-704F for fire inputs

PC5100

Addressable Zone Expander

• Connect up to 32 addressable detectors (AML)
• Detectors can be home-run, t-tapped or daisy chained
• Easy detector enroll process
• Compatible with the Power832® and Power864™ control panels

AMX-400

Loop Repeater/Isolator Module

• Can be used to repeat and re-power the AML loop to allow for longer wire runs:
  Requires 12 VDC power source
• Will isolate the wire run in the event of a problem

AMB-770

Loop Isolator Module

• Can be used to isolate burglary detectors from fire detectors on the same wire run